Corrugated Plastic Tote Suppliers introduces the requirements for the use of hollow plates:

1. Cleaning of the hollow board: It is necessary to clean it with warm water below 60℃. Use a neutral scouring agent when cleaning, do not allow to use of a scouring agent that has a corrosive effect on the endurance board. Begged to use a thin cloth or sponge dipped in neutralizing liquid to clean it secretly.

2. It is forbidden to use old coarse cloth, soft brush, mop, and other hard and sharp special tools for cleaning. The unsuitable cleaning agent is an alkaline solution, which will attack the surface. It is forbidden to use esters, macrolides, benzene homologs, and all chemical substances that can melt or solubilize polycarbonate.

3. Storage and transportation of hollow boards: Keep them indoors, and never allow direct sunlight or rain; stack them by hand, and the stack height should not exceed two meters. No heavy objects shall be placed on the boards, and no hard objects shall be placed between the boards. The storage room must be clean, dry, and prevent dust from intruding. No other chemical substances should be stored indoors at the same time.

4. During storage, do not damage or remove the maintenance film. During transportation, it must be placed flat on a clean flat pallet with an area larger than the board. If necessary, it should be properly tied to prevent vibration and sliding. Pay attention to the maintenance of the board edge to prevent damage and the double-sided maintenance film to keep it intact.

5. Precautions for using hollow board: When installing, the construction organizer must clarify the text printed on the maintenance film and understand the precautions clearly.

6. Do not remove the maintenance film in front of the equipment. Only lift the maintenance film up and down 50 mm along the borderline of the board. Remove the maintenance film immediately after the end of the equipment. If it is necessary to maintain the surface again, remove the film first, and then cover the maintenance film again. The viscous chemical substance of the sealing material solves the PC sun panel without damage.